Vores kunder ligger øverst på Google

Google Ads Specialister fra Vestjylland

Vi er 100% dedikerede til Google Annoncering – Vi har mange års erfaring med Google Ads og den bruger vi på at opsætte, optimere & vedligeholde vores fantastiske kunders konti.

100% Specialiseret i Google Ads
Vi har mange års erfaring fra +300 konti
Ingen lange bindinger & evighedskontrakter
Jævnlig opfølgning med hver enkelt kunde
Vi tager din virksomhed seriøst
KONTAKT OS
LÆS UDTALELSER & SUCCESHISTORIER

9 results (0,13896 seconds)

Show all filters

Brand

Merchant

Price (EUR)

Reset filter

Products
From
Shops

Sandvik Coromant 880-03 03 W06H-P-LM INSERT GRADE H13A

Sandvik Coromant 880-03 03 W06H-P-LM INSERT GRADE H13A

CoroDrill 880 Insert For Drilling Insert Usage Code - P Insert Grade H13A (M20)(K20)(N20)(S20) Uncoated grade for use on Stainless Steel,Cast Iron,Non-ferrous Material and Heat Resistant Super Alloys Guide to Geometry/Feed: -GM geometry is the basic choice for most materials. Medium feed. -LM geometry is the best choice for long chipping materials, e.g. low carbon steel and stainless steels. Medium feed, insert with sharp positive edge. -GR geometry is the high feed choice for steel and cast iron. Insert with strong reinforced edge, suitable for roughing. -GT geometry is a problem solver for unstable conditions and interrupted cuts. Low to high feed. Good chip control in most materials.

GBP 0.00
1

Sandvik Coromant 880-06 04 W08H-P-LM INSERT GRADE 4044

Sandvik Coromant 880-06 04 W08H-P-LM INSERT GRADE 4044

CoroDrill 880 Insert For Drilling Insert Usage Code - P Insert Grade 4044 (P40)(M35)(K20)(N20)(S35)(H20) PVD (Ti,Al)N2 coated insert for use on Steel,Stainless Steel, Cast Iron, Non-ferrous Materials, Heat Resistant Super Alloys and Hardened Materials Guide to Geometry/Feed: -GM geometry is the basic choice for most materials. Medium feed. -LM geometry is the best choice for long chipping materials, e.g. low carbon steel and stainless steels. Medium feed, insert with sharp positive edge. -GR geometry is the high feed choice for steel and cast iron. Insert with strong reinforced edge, suitable for roughing. -GT geometry is a problem solver for unstable conditions and interrupted cuts. Low to high feed. Good chip control in most materials.

GBP 0.00
1

Sandvik Coromant DDJNR 2525-M15 TOOLHOLDER

Sandvik Coromant DDJNR 2525-M15 TOOLHOLDER

DDJNL/R T-Max P Shank Tool For Turning Sandvik CBN holders deliver: High -productivity, high-quality finish turning of case-hardened steel surfaces. HPT is mainly to be found in transmissions components ? axles, shafts and gears in case hardened steels. These opportunities are found in Automotive as well as heavy equipment, wind power and mechanical engineering. The purpose is often to replace grinding with HPT and produce surface finishes with a quality level as ground.

GBP 0.00
1